{{item.currency}} {{pricing}}





{{item.currency}} {{pricing}} {{item.currency}} {{item.normalPrice}}



{{item.currency}} {{pricing}} - Out of Stock

Applies to:

 Machine Operators.

Objective:

It is to provide the systematic procedure on how to operate and wash the chip dump machine.

Policy or Handbook Reference

Refer to owner’s manual.

Pre-Requisites

Prior to use inspect the machine and electrical cords for visible damage.

 

Introduction

The main aim of this report is to provide the systematic procedure on how to handle, operate and wash the chip dump machine.

Definitions and term references

Chip dump – warming chips.

 

Completing the work effort for the chip dump

 

Step

Instruction

Illustration

Expected Result

 

Installation and Operation

 

 

1

Use the base of the chip warmer to lift it.

 

2

Plug appliance to mains outlet.

 

 

3

Turn on rocker switch.

The illuminating lamp will burn continuously.

4

Avoid piling cooked chips more than two layers on a chip dump

 

Chips that are piled too high will steam themselves and go squelchy very quickly.

5

Keep hold time to a minimum – keep regular chips under the chip warmer for no more than 7 minutes.

 

 

6

 

Cleaning

 

 

6 a

Always ensure that the chip dump is disengaged from the main power supply before cleaning.

 

 

6 b

Chip dump should not be cleaned with a water jet or dipped in water. Use only damp cloth or sponge dipped in soapy water.

 

 

6 c

Wipe off the chip dump with a dry cloth and wait at least 30 minutes before reconnecting to the mains outlet.

 

 

7

Clean, wipe and wrap the chip dump when done using it.

 

 

 

 

Troubleshooting

 

 

8

  1. Is the power switched OFF? The power should be ON.

  2. Has a circuit tripped out? Re-set/repair as necessary.

  3.  Is the 3-pin plugged firmly into the wall socket? Check another appliance such as a toaster or kettle in the same socket.

 

 

9

 

Safety instructions

 

 

 

  1. When this warmer is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finishes, etc. It is recommended that they must be made of non- combustible material for fire prevention. 

  2. Ensure that the fire cord does not encounter hot surfaces.

  3. If the supply cord is damaged, it must be replaced with a new cord assembly available from the supplier’s agent.

 

 

 

Expected results

This will keep the chip dump in a good condition.