{{item.currency}} {{pricing}} - Out of Stock
Applies to: |
Machine Operators. |
Objective: |
It is to provide the systematic procedure on how to operate and wash the Gas crepe plate. |
Policy or Handbook Reference |
Refer to owner’s manual. |
Pre-Requisites |
Prior to use, you must perform a complete leak test |
Introduction
The main aim of this report is to provide the systematic procedure on how to handle, operate and wash Gas crepe plate.
Definitions and term references
Gas crepe plate –
Completing the work effort for the Gas crepe plate
Step |
Instruction |
Illustration |
Expected Result |
|
Installation and testing guide |
|
|
1 |
Connect to gas. Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water). |
|
|
2 |
Apply several drops of solution where hose attaches to regulator. |
|
|
3 |
Apply several drops of solution where regulator connects to cylinder. |
|
|
4 |
Make sure all crepe plate and light valves are OFF. |
|
|
5 |
Turn cylinder valve ON. |
|
|
6 |
If bubbles appear at any connection, there is a leak. 1. Turn cylinder valve OFF. 2. If leak is at hose/regulator connection: tighten connection and perform another leak test. If bubbles continue appearing, the hose should be returned to the place of purchase. 3. If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another leak check. If you continue to see bubbles after several attempts, cylinder valve is defective and should be returned to cylinder’s place of purchase. If NO bubbles appear at any connection, the connections are secure. |
|
|
|
Operating guide |
|
|
7 |
Turn the control knob to the “OFF” position. |
|
|
8 |
Fully open cylinder valve. |
|
|
9 |
Set the thermostat to desired position.
|
|
|
10 |
Push and release the igniter button. |
|
|
11 |
Now the crepe plate is ready to use. |
|
|
12 |
To switch it OFF, turn the control nob to “0”/OFF position and turn the cylinder valve OFF |
|
|
|
Cleaning guide |
|
|
4 |
Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents. |
|
|
5 |
While cleaning your unit, do not submerge the control valve assembly. If the gas control is submerged in water, do not use it. It must be replaced. |
|
|
6 |
Use only warm soapy water and a soft cloth when cleaning the appliance. |
|
|
7 |
Clean and wipe the Gas crepe plate when done using it.
|
|
|
|
Troubleshooting guide |
|
|
|
1.Burner won’t light. Clear blockage. Turn control knob to ON.
|
|
|
|
Safety Instructions |
|
|
10 |
|
|
|
Expected results
This will keep the Gas crepe plate in a good condition.